Maintenance And Care; Switching Off The Electricity; Clean The Filter After Each Cycle; Check The Drum After Each Cycle - Hotpoint Ariston AQUALTIS AQC9 4F5 Mode D'emploi

Maintenance and Care

Switching off the electricity

GB
!
Unplug the dryer when not using it, when cleaning it, and
during maintenance activities.

Clean the filter after each cycle

The filter is an important part of your dryer: it accumulates
lint and fluff that is formed while drying.
When finished drying, clean the filter by rinsing it under
running water or with your vacuum cleaner. Should the
filter become clogged up, the airflow inside the dryer will be
seriously compromised: drying times lengthen and you will
consume more energy. It may also damage your dryer.
The filter is found in front of the dryer trim (see diagram).
!
Do not use dryer without replacing the filter.

Check the drum after each cycle

Turn the drum manually in order to remove small items
(handkerchiefs) that could have been left behind.
Cleaning the drum
!
Do not use abrasives, steel wool or stainless steel
cleaning agents to clean the drum.
A coloured film may start to appear on the stainless steel
drum, this may be caused by a combination of water
and, or cleaning agents such as fabric conditioner from
the wash. This coloured film will not affect the dryer
performance.

Empty the Water Container after each cycle

Pull the container out of the dryer and empty it into a sink or
other suitable drain. Replace container securely.
Water Contaniner
70
Removing the filter:
1. Pull the plastic grip of the
filter upwards (see diagram).
2. Open the filter by
depressing the clip.
3. Clean the lint from the
inside of the filter, and
replace it correctly. Ensure
the filter is fully located flush
into the tumble dryer trim.
Heat Pump
Filter Unit
Catches
Always check and empty the container before you start a new
drying programme.
Cleaning the Heat Pump Filter Unit
• Periodically (every 5 drying cycles) remove Heat pump
filter unit and clean any build up of fluff from the
surface of the filter by rinsing it under running water or with
your vacuum cleaner.
We however recommend that you clean this filter after
every drying cycle to optimize the dryers performance.
To remove Heat pump filter unit:
1. Unplug the dryer and open the door.
2. Remove the filter unit by rotating the 4 clips to the vertical
position then pulling the filter unit towards you.
3. Separate the two parts of the filter unit
and clean the surface of the filter.
! Warning: The front of the heat pump
is made from thin metal plates.
Take care that you do not damage these
or cut yourself when cleaning, removing
or replacing the filter unit.
4. If there is any build up of fluff on the
plates Carefully clean this off with a
damp cloth,sponge or vacuum cleaner. Never use your Fingers.
5. Assemble the two parts of the filter clean the surface of the
seals and replace with the 4 clips into the horizontal position,
sure that the catches have been secured.

Cleaning the dryer

• External parts in metal or plastic and rubber parts can
be cleaned with a damp cloth.
• Periodically (every 6 months) vacuum the front Air intake
grille, to remove any build up of fluff, lint or dust. Also to
remove accumulation of fluff from the front of Heat Pump filter
unit and filter areas, clean occasionally with a vacuum cleaner.
!
Do not use solvents or abrasives.
!
Your dryer uses special bearing components which do not
need lubrication.
!
Have your dryer checked regularly by authorized technicians
to ensure electrical and mechanical safety (see Service).
Filter
Air Intake
Heat Pump Filter
Handle
Unit Cover