Installation; What's In The Box; Mounting The Inverter - Furrion net-zero FIVBDP10A Manuel D'instructions

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Installation

What's in the Box

Make sure you have all the following items
included in the packaging. If any item is
damaged or missing, contact your dealer.
Power Inverter x 1
Instruction Manual x 1
Warranty Card x 1

Mounting the Inverter

The inverter has four slots in its mounting
bracket that allows the unit to be fastened
against a bulkhead, floor, wall or other flat
surface. (Fig. 1)
Fig. 1
The inverter can be operated in any position,
however, if it is to be mounted on a wall,
mount it horizontally (see Fig. 2 for correct
mounting direction) so that indicators,
switches, outlets and terminal blocks located
on the front panel are visible and accessible.
If inverter is to be installed in a moving
vehicle, it is strongly recommended that the
inverter be shock-mounted either on the
floor (in a clear, safe area) or on a secure flat
surface.
Fig. 2
The power inverter should be installed in
an environment that meets the following
requirements.
● DRY – Do not allow water to drip on or
enter into the inverter.
● COOL – Ambient air temperature should
be between 0°C and 40°C, the cooler the
better.
● SAFE – Do not install the inverter
in a battery compartment or other
areas where volatile fumes may exist,
such as fuel storage areas or engine
compartments.
● VENTILATED – Keep the inverter (25mm
at least) away from surrounding objects.
Ensure the ventilation area of the unit is
not obstructed.
● DUST – Do not install the Inverter in dusty
environments. The dust can be inhaled
into the unit when the cooling fan is
working.
● FUSED – A fuse must be applied between
the battery and the Inverter.
● CLOSE TO BATTERIES – Avoid excessive
cable lengths. Do not install the Inverter
in the same compartment as batteries.
● Use the recommended wire lengths and
sizes.
● Do not mount the Inverter where it will
be exposed to the gases produced by the
battery. These gases are very corrosive,
and prolonged exposure will damage the
Inverter.
6

Publicité

Chapitres

Table des Matières
loading

Table des Matières