Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Ethernet Configuration
To set the Net-X to receive and send either Art-Net™ or sACN, follow the instructions below:
1. Press <MENU> repeatedly until <Protocol> shows on the display.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to select ArtNet or sACN.
4. Press <ENTER>.
Art-Net™ Subnet Address
There are 16 Subnet sets of 16 universes available to the Net-X, for a total of 256 universe
addresses. The Subnet address must be configured if the Net-X is being used as an Art-
Net™ node. The Net-X can only convert (to DMX) or merge Art-Net™ signals in the 16
universes within the Subnet it is assigned to.
The Universe address will always read 0–15. For Universes 0–15, assign Subnet 0. For
Universes 16–31, assign Subnet 1. For Universes 32–47, assign Subnet 2, and so on.
For example: to assign Universe 110 to a DMX Out port, set the Subnet address to 6, and the
Universe of that port to 14. To assign Universe 200 to a DMX Out port, set the Subnet to 12
and the Universe of that port to 8.
To assign the Subnet address, do the following:
1. Press <MENU> repeatedly until <Subnet> shows on the display.
2. Press <ENTER>. The number in the lower right-hand corner of the display flashes.
3. Use <UP> or <DOWN> to select the Subnet address, 0–15.
4. Press <ENTER>.
Configuring IP Addresses
The IP addresses are the addresses of the Net-X on the network. They must be configured if
the Net-X is being used as an ethernet node.
In sACN mode, the beginning number can be set to 2, 10, or 239.
In Art-Net™ mode, the beginning number is set by the Net Setting.
The other three numbers can be set from 0–255. The IP addresses cannot be identical.
To configure the IP Address, do the following:
1. Press <MENU> repeatedly until <IP Address #X> shows on the display.
2. Press <ENTER> to cycle through the sets of 3 digits in either address, until the desired
number flashes on the display.
3. Press <UP> or <DOWN> to change that set of numbers.
4. Repeat steps 2–3 until the IP address is configured as desired.
5. Press <MENU>.
Configuring Art-Net™ Net Setting
The Net setting controls the beginning of the IP addresses on the Net-X in Art-Net™ mode.
To configure the Net setting, do the following:
1. Press <MENU> repeatedly until <Net> shows on the display.
2. Press <ENTER>. The number in the lower right-hand corner of the display flashes.
3. Use <UP> or <DOWN> to select either:
·
0, to set the beginning of the IP addresses to 2
or
·
1, to set the beginning of the IP addresses to 10.
Note: 2–127 are reserved for future use.
4. Press <ENTER>.
WARNING: Do NOT set the Net to any value higher than 1. They are reserved for
future use and have no function.
Net-X User Manual Rev. 5
Configuration And Operation
Page 16 of 65
Publicité
Table des Matières
