Vox VC-12 Manuel D'utilisation page 4

Welcome
C
ongratulations on buying the VOX
VC-12 Foot Controller—a pedal
board for controlling VOX BUS-
compatible equipment, including VOX
Valvetronix amps.
To get the most out of your VC-12 Foot
Controller, please read this guide carefully.
Features
You can use your VC-12 Foot Controller to do
the following:
• Select programs
• Control your amp's volume
• Control the VOX-WAH effect
• Control the speed of the U-VIBE effect
• Control the speed of modulation effects
• Set the delay time by using the TAP switch
• Turn the Pedal, Modulation, Delay, and
Reverb effects on and off individually
• Instantly recall a previously-selected
program
• Tune your guitar
• Store your Valvetronix amp's program data
To discover which of these features you can
use with your VOX BUS-compatible equip-
ment, refer to the relevant product manual.
Care
The VC-12 was designed and built to with-
stand heavy usage, but you should still look
after it and observe the following points:
• Don't move or pick up the VC-12 by the
pedals. Always hold the main body.
• Disconnect all cables before putting away
the VC-12.
• To clean the VC-12, use a damp, soft cloth,
such as a guitar cleaning cloth.
4
Hooking Up the VC-12
T
he VC-12 can be connected to VOX
BUS-compatible equipment, including
the following Valvetronix amps:
AD60VT, AD120VT, AD60VTH, AD120VTH,
AD60VTX, and AD120VTX.
1. Turn off all equipment before making
any connections.
2. Connect the included cable to the VOX
BUS MAIN connector on the rear panel
of your VC-12.
Connect one end of the included cable here
The VC-12 receive power via this connec-
tor.
3. Connect the other end of the cable to
the FOOT CONTROLLER connector or
VOX BUS connector on your Valvetronix
amp or VOX BUS-compatible device.
Connect the other end of the included cable here
VOX BUS-compatible device
About the Included Cable
The included cable is a 10Base-T "straight"
cable with secure latching system.
Note: The included cable is for connecting
the VC-12 to VOX BUS-compatible equip-
ment. Do not use it for any other type of
connection.
If you need to buy a replacement, or addi-
tional cable, contact your VOX dealer. Alter-
natively, you can use a standard 10Base-T
computer network cable. Make sure you get a
"straight" cable, not a "crossed" cable.
Warning: Using a 10Base-T "crossed" cable
will damage the connected device and
invalidate your warranty.
VC-12