NQ70R5510DG_AA_DG68-01148A-00_EN.indd 47
4.
Lower the oven door to the fully open
position. If the oven door does not open
to a full 90°, repeat steps 1 through 3.
5.
Locate the oven door hinge locks in
the corners of the oven door, and then
rotate the hinge locks toward the oven
cavity to the locked position.
See Step 3 (illustration A) in the
"Removing the oven door" section for
the proper locked position.
6.
Close the oven door.
7.
When the hinges are properly installed
and the door is closed, there should be
an even gap between the door and the
control panel. If one side of the oven door
is hanging lower than the other, the hinge
on that side is not properly installed.
Changing the oven light (Lower oven only)
The oven light is a standard 40-watt appliance halogen bulb. It comes on when the
oven door is open. When the oven door is closed, touch
or off. It will not work during a self-cleaning.
1.
Important: The broil heater is not a
01
removable part. Do not force the broil
heater down. Do not let it drop down.
2.
3.
4.
5.
Before changing your oven light, disconnect
the electrical power to the oven at the main
fuse or circuit breaker panel. Make sure the
oven and the halogen bulb are cool.
to turn the light on
To change the halogen bulb, you must
tilt the broil heater down. To do this,
turn the circular nut on the support
counterclockwise while holding the
broil heater. The broil heater should
loosen and tilt down.
NOTE
Remove the glass cover.
Remove the halogen bulb cover.
Replace the halogen bulb.
When done, replace the halogen bulb
cover, replace the glass cover, and then
follow Step 1 above in the reverse
order to return the broiler to its correct
position.
CAUTION
English 47
2019-04-03
2:12:40