Lubrication - Silverline 344944 Mode D'emploi

GB
General inspection
• Regularly check that all the fixing screws are tight
• Inspect the supply cord of the tool, prior to each use, for damage or wear. Repairs should be
carried out by an authorised Silverline service centre. This advice also applies to extension cords
used with this tool
Cleaning
• Keep your tool clean at all times. Dirt and dust will cause internal parts to wear quickly, and
shorten the machine's service life. Clean the body of your machine with a soft brush, or dry cloth.
If available, use clean, dry, compressed air to blow through the ventilation holes
• Clean the tool casing with a soft damp cloth using a mild detergent. Do not use alcohol, petrol
or strong cleaning agents
• Never use caustic agents to clean plastic parts

Lubrication

• Slightly lubricate all moving parts at regular intervals with a suitable spray lubricant
Brushes
• Over time the carbon brushes inside the motor may become worn
• Excessively worn brushes may cause loss of power, intermittent failure, or visible sparking
• If you suspect that the brushes may be worn, have them replaced at an authorised Silverline
service centre
Troubleshooting
Problem
No function when ON/OFF
Switch Box (9) is operated
Motor does not start
Poor surface finish after
planing
Barrel not rotating
Vibration and abnormal noise
10
Possible cause
No power
Power overload has triggered
automatic overload protection
Defective ON/OFF Switch Box
Carbon brushes worn
Chosen cutting depth too big
Blunt blades
Wood is damp
Broken drive belt
STOP using tool immediately
Storage
• When storing, always cover the Blade Drum (3) using the Blade Cover (25)
• Store this tool carefully in a secure, dry place out of the reach of children
Disposal
Always adhere to national regulations when disposing of power tools that are no longer functional
and are not viable for repair.
• Do not dispose of power tools, or other waste electrical and electronic equipment (WEEE), with
household waste
• Contact your local waste disposal authority for information on the correct way to dispose of
power tools
Check power supply
Turn OFF the tool at ON/OFF Switch Box then press the Overload
Protection Reset Switch (26). Turn tool ON then continue use
Replace the ON/OFF Switch Box at an authorised
Silverline service centre
Brushes need replacing
Reduce cutting depth and work in several passes instead
Turn or replace blades (see 'Changing blades')
Switch off immediately. Evaluate and correct positioning of
blades (see 'Blade replacement')
See 'Drive belt replacement' and replace belt
Re-check all user accessible parts are secure and correctly fitted
Contact an authorised Silverline service centre
Solution