Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1
3
4
5
6
3
HEAT
*For mark 6 button, it is AUTO MODE for coolling only, and it is
HEAT for heating model.
1.
Power:
Turn the air conditioner on and off.
2.
Cool:
Press the COOL button to COOL mode.
3.
and
:
Use these buttons on the control
panel and remote to increase or decrease the
Set Temperature or Timer. Temperature range:
61 ~88
or 16 ~31 .
4. Sleep:
Press the SLEEP button, the Sleep
Light will be on after 10
left lights will be off. In SLEEP mode, the
air-conditioner will automatically adjust the
temperature and fan speed to make the room
more comfortable during the night. The set
temperature will automatically raise by 1ºF or
2ºF every 30-60 minutes and at most change
six times until the set temperature is 82ºF.
And every running time depends on the set
temperature.
2
7
8
9
10
seconds
, and all the
5. Timer:
Use these buttons on the control panel
and remote to set the Timer.
Timer Off: The timed stop is programmed by
pressing TIMER button. Set the rest time by
pressing the button
time displayed is to your
TIMER button again.
Timer On: When the unit is off, press TIMER
button at the first time, set the temperature with
pressing the button
button at the second time, set the rest time with
pressing the button
button at the third time, confirm the setting, then
the rest time to next automatical switching-on
could be read on the display of the machine.
Note: It can be set to automatically turn off or on
in 0.5-24 hours. Each press of the
buttons will increase or decrease the timer. The
Timer can be set in 0.5 hours increment below
10 hours and 1 hour increment for 10 hours or
above. The SET light will turn on while setting.
To cancel the set function, press the TIMER
button again.
6. a.Auto Mode:
In AUTO mode the unit automatically
chooses the fan speed and the mode of operation
(COOL,DRY or FAN).In this mode the fan speed
and the temperature are set automatically according
to the room temperature (tested by the temperature
sensor which is incorporated in the indoor unit.).
It is for cooling only model.
b.HEAT: Press the HEAT button to HEAT mode.
It is for heating model.
7. Fan Speed:
Press the FAN SPEED button to
choose the fan speed options. You can choose
Hi, Med, Lo or auto speed in COOL mode and
choose Hi, Med, Lo in FAN mode.
8. Display:
To press the DISPLAY button, it can
switch off/on all lights or LED display.
9.
Eco:
When the unit is in ECO mode, the light
will turn on. In ECO mode, the unit will turn-off
once the room is cooled to the user set
temperature. The fan will also be off at this
point. The unit will turn back on when the room
temperature rises above the user set
temperature.Before the compressor stars, the fan
motor will run for a while, then it will stop for a
while-and will repeat to provide a much more
comfortable-feeling and save energy.
10.
Fan Only:
Press the Fan Only button to FAN
ONLY mode.
10
or
until the rest
then press the
liking
or
. Press TIMER
or
. Press TIMER
Publicité
Chapitres
Table des Matières
