JETStream LIBRA 3 Instructions De Montage Et Mode D'emploi page 9

1
dimensions in cm
6
water level pool wall
clamping frame
gasket
screw 6 x 30
clamping frame
gasket
screw 6 x 30
max.
INSTRUCIONS FOR AUTHORIZED PERSONS ONLY
Before installation
The safety instructions must be read carefully before installation. You must definitely fulfil the requirements stated by
the uwe company and by the standard authorities. If the instructions are not observed, the installation engineer shall
bear the sole responsibility. The manufacturer shall thus be absolved of any liability.
See drawing 7 on the last folded page.
MOUNTING THE NOZZLE ASSEMBLY (fig.7)
Moisten the gasket rings (1) of the nozzle assembly (2) and push the assembly into the wall fitting (30) until the front
plate rests against the tiles in the case of tiled/mosaic pools. Ensure that the countersunk holes on the nozzle assembly
line up with the threaded holes in the wall fitting. Insert the countersunk screws (3) and screw in without over tightening.
Repeat the above operation as necessary.
concrete
shuttering
nozzle
housing
strut for air
inlet
nozzle housing
proposal:
nozzle housing 3- 5 may be
installed horizontally at 1,5 m
centre approx. or diagonally to
a distance 60 cm from pool-
floor
suction tube
stopper 2"
suction housing
protective sleeve
for pneumatic tube
Wall thickness
24 -100 cm
pneumatics switch
housing
(optionally)
suction
housing
stopper 2"
shuttering
use clamping frame
for cutting and drilling
dimensions in cm
9
2
render & tile
to inner edge
render & tile
6 cm max
3
render & tile
to inner edge
render & tile
6 cm max
4
liner
clamping
frame
screw
5
liner
clamping
frame
screw
rubber-
gasket
one
rubber
gasket to
either side
of liner
rubber-
gasket
one
rubber
gasket to
either side
of liner