Canon RS-CL07 Manuel D'installation page 22

6
Attach the top of the extension pipe
to the Ceiling-mount bracket
Secure to the extension pipe using the four
supplied M5 screws.
● The open end of the pipe should face the open
end of the Ceiling-mount bracket as shown.
7
Attach the Joint fitting to the bottom
of the extension pipe
Use the four M5 screws removed from the
Ceiling-mount bracket during preparation.
8
Hook the Base bracket on the
projections of the Joint fitting and
secure it temporarily
1 Hook the Base bracket on the protrusion
(A) of the Joint fitting, and secure it
temporarily using the four supplied M5
screws (B).
Tighten the screws (B) after making the
adjustment in "Adjusting the Projection
Angle" (page 11).
2 Affix the supplied Canon logo seal.
For the direction and position of the logo
seal, see the refer to step 8 on page 7.
Direction to the
screen
B
Direction to the
screen
Direction to the
screen
A
B