Diagram Spare Parts - Joannes G50/2 oil Notice D'utilisation Et D'entretien

pag. 84
SIGNS
1 THEBURNER DOES NOT START
AND THERE IS NO BLOCK
WARNING
2 THE MOTOR OPERATES BUT DOES
NOT ORIGINATE THE FLAME
3 THE BURNER STARTS, ORIGINATE
THE FLAEM AND THEN STOPS.
4 THE FLAME IS IRREGULAR, IT IS
SHORT WITH SPARKS.
5 THE FLAME IS SMOKY
POSSIBLE CAUSES
A. Lack of electrical input.
B. The fuel does not reach the burner.
A. The discharge to the electrodes
does not occur.
B. The nozzle is obstructed.
C. The fuel does not arrive.
A. The photoresistor is dirty.
B. The nozzle does not atomise
properly.
A. The nozzle does not atomise
properly
B. The pressure in the pump is too
low.
C. There is water in the light oil.
A. The nozzle does not atomise
properly.
B. The combustion air is inadequate.
WORKING ANOMALIES
REMEDIES
A. Check the fuses
B. Check the thermostats (ambient,
boiler and safety).
C. Check the supply line.
A. Call the technician.
B. Call the technician.
C. Check the level of the light oil in
the tank; check that the shutters
along the light oil line are open.
A. Clean the photoresistor.
B. Call the technician.
A. Call the technician.
B. Call the technician.
C. Remove the water from the tank
and clean the filters.
A. Call the technician.
B. Call the technician.