Sleep Timer; Display Backlight Dimmer - Brandt BCR97P Notice D'utilisation

SLEEP TIMER
1. Press SL twice to enter the sleep mode.
 "SL" and "05" will flash on the display.
2. While the sleep time is flashing, repeatedly press SL to set the desired sleep time from 5, 15,
30, 45, 60, 75 or 90 minutes.
3. The radio will be turned off after the set sleep time has elapsed.
To check remaining sleep time, press SL.
To turn off the radio before the sleep time has elapsed, press
DISPLAY BACKLIGHT DIMMER
In order to adapt the intensity of the display to suit the ambient room lighting, repeatedly press
to select the dimmer brightness between High and Low. This can only be done when the radio is off or the
unit is not sounding.
PROJECTION
With this projection function, you can conveniently project the clock time onto a surface e.g. walls.

To turn on or off the projection, press .

To change the projection slightly to a different angle, rotate the projector knob.

To flip projected time upside down, press and hold .
NOTE:
If projection is illuminated, do not look directly into the projector.
The maximum projection distance is 1 metre.
SPECIFICATIONS
FM frequency: 87.5‐108 MHz
Input: DC5.5V 500mA
Battery back up: 1 x CR2032 (not included)
We apologise for any inconvenience caused by minor inconsistencies in these instructions, which may occur as
a result of product improvement and development.
.
Darty Plc © UK: EC1N 6TE 10/03/2014
EN.6