Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
GETTING TO KNOW YOUR GEL/LATHER HEATING SYSTEM
13
9
1
1) Gel nozzle
2) Lather nozzle
3) Adjustment switch
4) Power "OFF" button
5) Ready indicator light
6) Power "ON" button
7) Variable temperature control
8) Locking tab
9) Gel release button
10) Protective cylinder
11) 120V power cord (not shown)
12) Control cap: Press down to dispense lather or press down and slide
adjustment switch (3) to lock for gel use.
13) Cap removal tool (stored at the bottom of the protective cylinder)
3
12
4
6
7
5
2
11
8
10
VERY IMPORTANT SETUP INSTRUCTIONS
adjustment switch
STEP 1
- Attach proper nozzle, lather or gel, by twisting
- Be sure the adjustment switch is in the "lather"
CAUTION: Always use the gel nozzle for gel and lather nozzle for lather.
STEP 2
- Use cap removal tool found in the bottom of base
can valve
locking tab
STEP 3
- Turn unit upside down, as shown
- Depress locking tab
- Carefully line up can valve with center seal
- Gently insert can valve into seal and release
- Press can until it locks in place
center seal
IMPORTANT NOTE: If can valve is not properly inserted into center seal,
product will leak out of unit.
into place
position for lather or "gel" position for gel set-up
to remove plastic cap on can
locking tab
Publicité
Table des Matières
