Electrical Connection - SOLIS Design Line IQ-7 Mode D'emploi

Electrical connection

The assembly may only be carried out by a qualified expert.
1. Loosen the front cover and remove it (see fig. 4).
2. Electrical connection with mains: fix the mains in clamp (2) and clamp the mains with
the cable clamp (3) (see fig. 5).
Electrical connection with flush connection: open the basis at the defined place (1) and
connect the connection wires (230/240 V) to the clamp (2) (see fig. 5).
3. Check the assembly again and mount the front cover.
4. Switch on the power and the on/off switch.
1
3
1 Set the on/off switch to the position "0".
2 Unlock the front cover by pushing the two
E
openings at the lower end of the front
cover to the inside with two sharp items.
3 Take the front cover off to the top.
Solis of Switzerland Ltd
Solis-House • CH-8152 Glattbrugg-Zurich • Switzerland
Phone +41 44 874 64 54 • Fax +41 44 874 64 99
info@solis.ch • www.solis.ch • www.solis.com
42
Solis_IQ-7_DesignLine-Betreibsanleitung.indd 42
3
Fig. 4
2
2
1
3
1 Wire entry opening
2 Clamp
3 Cable clamp
Fig. 5
16.06.16 11:24