SOLIS Design Line IQ-7 Mode D'emploi page 40

Assembly instructions
for the wall mounting
- Mark the positions of the two dowel
holes with a pen (boring template, fig. 3).
- Drill the two holes with a 4 mm drill.
- Put the supplied dowels in the holes.
- Screw one of the attached screws in the
upper dowel until the distance between
the wall and the screw head amounts to
ca. 6.5 mm (see fig. 1).
- The wall mounting can now be hung in
with the upper screw and is fixed with
the lower screw.
4 mm
E
40
Solis_IQ-7_DesignLine-Betreibsanleitung.indd 40
Fig. 1
Important note:
This wall mounting has to be fixed out
of reach of a person using the bath tub
or shower.
During the installation stage, please also
bear in mind the length of the mains cable
and the position of the socket.
The hairdryer must not be within the reach
of a person in the bathtub or shower when
the cable is extended to its maximum length.
20 mm 6,5 mm
16.06.16 11:24