Frequency Selection; Selecting The Country Preset; Manual Adjustment In Mhz; Manual Selection From A Preset - Harman AKG PR4500 Mode D'emploi

• The selected volume setting remains stored in memory upon powering down and will
be restored automatically upon powering up again.
• The volume setting affects the headphone output level only and does not affect the
LINE output.
The WMS 4500 Series is exceptionally frequency agile. You can either set the receiving fre-
quency manually in MHz or select it automatically from pre-programmed frequencies for
even quicker and easier system setup. All frequencies have been optimized by AKG for si-
multaneous operation of several radio channels and are subdivided into Presets for specific
countries or regions, Groups, and Channels.
• You can select the receiving frequency in one of the following ways:
-

Manual adjustment in MHz.

- Manual selection from pre-programmed frequencies.
- Automatic selection of a clean frequency from a Group.
- Automatic selection of a clean frequency from a Group containing a selectable
number of clean frequencies for applications where several wireless microphones
will be used.
1. When you switch power to the receiver on for the first time, the "NAME" label and the
name of the first programmed Preset will be flashing.
• To select the appropriate Preset for a specific country later on (e.g., when traveling), hold
down the setup control and press the ON/OFF button.
2. Turn the setup control up or down to select the desired Preset (country code).
3. Press the setup control briefly. The receiver will start up and automatically indicate the
first Channel ("CH") of the first Frequency Group in memory. The receiver is in SETUP
mode so you can easily select a different frequency.
1. In SETUP mode, turn the setup control up or down as many times as needed to call up
the frequency screen.
2. Press the setup control briefly.
3. The MHz value starts flashing: To increase the value, turn the setup control briefly up.
To decrease the value, turn the setup control briefly down.
4. Press the setup control briefly.
5. The kHz value starts flashing: To increase the value, turn the setup control briefly up.
To decrease the value, turn the setup control briefly down.
1. In SETUP mode, turn the setup control up or down as many times as needed to call up
the Preset screen.
2. Press the setup control briefly.
3. "NO CH" flashing: Turn the setup control up or down to select the number of channels
you need (e.g., "8" for an 8-channel system). This makes sure that the system will al-
ways be able to find enough clean frequencies within the same Frequency Group.
4. Press the setup control briefly.
5. Turn the setup control up or down to select ta Group.
6. Press the setup control briefly.
7. Turn the setup control up or down to select ta Channel.
3 Setting Up
Note

Frequency Selection

Selecting the
Country Preset
Refer to fig. A2 in the Appendix.
Note
Manual Selection in MHz
Refer to fig. A3
in the Appendix.
Manual Selection
from a Preset
Refer to fig. A4.1
in the Appendix.
27