Getting Started Quickly - Harman AKG PR4500 Mode D'emploi

1
Insert the supplied batteries into the receiver.
2
3
Select a clean frequency on the receiver manually (fig. A3) or using the automatic search function (fig. A4).
4
Tune the transmitter to the same frequency you selected on the receiver (refer to transmitter manual).
5
6
Connect your headphones to the receiver.
7
Switch power to the receiver on and set the headphones volume to the desired level. (Refer to page 26, "Setting
the Headphones Volume".)

Getting Started Quickly

Switch power to the re-
CH
ceiver on and select the
code for the country where
you are going to operate
your receiver (refer to "Se-
lecting the Country Preset"
on page 27 and fig. A2 in
the Appendix).
F F i i g g s s . . A A 4 4 , , A A 5 5
Use one of the supplied connecting cables to
connect the LINE OUT jack on the receiver to
the camera or recording device. See page 13.
19