Continuous Drainage - purline PLQ10M Manuel D'utilisation

Disconnect the unit from the wall socket before removing the
water tank.
While the water tank is full, the compressor will stop for self-
protection and the water full indicator will turn into red.
To move the water tank, pull it out squarely from the unit by
using the handle at the water tank.
After emptying the water tank, place the water tank into space.
Make sure it is properly positioned, in order for the water full
sign to go out and your dehumidifier is operating.
Please note in this case, the water tank has not been
positioned well, the water full indicator will turn into red.

CONTINUOUS DRAINAGE

PLEASE NOTE: BOTH THE WATER TANK AND THE
CONTINUOUS DRAINAGE CANNOT BE USED AT THE
SAME TIME.
When the dehumidifier is operated at very high humidity levels,
the water tank will require more frequent drainage. In this
situation, it may be more convenient to set the unit up for
continuous drainage with the following procedures:
Switch off and disconnect the unit from the wall socket before
proceeding. You must empty the water tank on a regular basis.
The water can be drained continuously by attaching a direct
drain hose to the unit (not included with the unit)
Installing a direct drain:
1. Pull out the stopper from the drain hole at the rear of
the machine (FIG.1) and connect the drain hole with a
water tube of inner diameter 12 mm (FIG.2)
NOTE: The water tube is not supplied with the unit.
1 Pull out the water tank. Use the stopper taken from the
hole to stick into drain hole B (FIG.3).
2 Ensure the water will always drain away freely and the
tube will remain in right place.
Note in very cold weather conditions, precautions should
be taken to prevent the water tube from freeing.