BOMANN TSG 7402 Mode D'emploi page 70

Water connection Water connection
Water connection Water connection
CAUTI CAUTI CAUTI CAUTION: ON: ON: ON:
• The Installation of the water supply must conform
to the local laws and regulations.
• The appliance is not not suitable for hot water supply.
not not
• Use the new supplied hose set to connect the
appliance to the water supply. Do not reuse old or
used connection sets.
• If the water pipe is new or long time not used,
ensure before connecting to the water system,
that the water is clear and free from contamina-
tion.
Notes on inlet hose safety system Notes on inlet hose safety system (delivery scope Notes on inlet hose safety system Notes on inlet hose safety system
depending on depending on model) depending on depending on model) model) model)
The safety system consists of a double-walled inlet
hose. It guarantees to cut off the water supply when
leakage of the inner hose. Switching off the water
supply leads over an electronic contact.
If necessary, you can order an inlet hose safety sys-
tem from your dealer or in our online accessories
shop, w w w w ww.bomann ww.bomann ww.bomann ww.bomann- - - - germarny.de germarny.de. To order, use the germarny.de germarny.de
reference number found under "Technical Data".
Set up drainage Set up drainage Set up drainage Set up drainage
• Attach the drainage hose to the appliance back.
The connector is provided with clamps and must
be fixed with a screwdriver
• Secure the end of the hose securely in a sink or
bucket. Fix the drain hose with suction cups.
(delivery scope (delivery scope (delivery scope
.
.
Set up water supply Set up water supply
Set up water supply Set up water supply
You can fill the appliance with water in two ways:
Permanent Perm anent connection via the tap connection via the tap
Perm Perm anent anent connection via the tap connection via the tap
NOTE NOTE: : : :
NOTE NOTE
The water pressure must be between 0.04-1.0 MPa.
With higher pressure: use a pressure regulator.
• Connect the water inlet hose to a water thread
with ¾". Screw the hose firmly in the direction of
the screw thread; pay attention for a tight fit.
• Connect the other end of the inlet hose to the inlet
valve on the appliance back; pay attention for a
tight fit too.
Manual filling of the 5 l Manual filling of the 5 l Manual filling of the 5 liter water tank Manual filling of the 5 l
• Remove the cap of the water tank opening and
add about 5 liter of water into the tank.
How to notice if there is enough water in the tank:
- Fill in standby modus: if the tank is filled with
enough water, several beeps will sound.
- After switching on: if there is not enough water in
the tank, the display shows [
As soon as enough water is available in the tank,
the symbol goes out and several beeps sound.
E E E E lectrica lectrical l l l connection connection
lectrica lectrica connection connection
WARNING: WARNING: WARNING: WARNING:
• The installation to the mains supply must conform
to the local standards and regulations.
• Improper connection may cause to an elect
shock! shock
shock shock
• Do not use multiple sockets or extension cords.
70
iter water tank iter water tank iter water tank
].
electric elect elect ric ric ric