CTC CLATRONIC BS 1247 Mode D'emploi & Garantie page 64

GB
64
05-BS 1247 neu 64
Cleaning the Filter Element
Important:
Always empty the dust container fi rst before re-inser-
ting the fi lter element.
Pull the fi lter element out carefully by holding both
clamps.
• Unlock the main fi lter by turning slightly (see illus-
tration). The fi lter can then be removed by pulling
downwards. Clean the fi lter by tapping and gentle
brushing.
• Now replace the components. It is important to
insert the sealing ring as otherwise the fi lter
will leak. Please tighten the main fi lter again,
taking note of the recesses.
Every third time the dust container is emptied, or in
the case of severe soiling, clean the fi lter by allowing
water to fl ow through the fi lter fabric against the
direction in which the vacuum cleaner blows. The
dust container should only be reinserted when it is
completely dry!
Now place this back in position once it has completely
dried!
Caution:
Never wash the fi lter in the washing machine, and
please do not use a hairdryer to dry it.
Motor protection fi lter (inlet fi lter)
The inlet fi lter is located in the dust container com-
partment. The fi lter is located vertically in the rear
section of the dust housing (see illustration). Pull the
fi lter out towards the front. Clean the motor protection
fi lter approximately every 10th time you empty the
dust container. If necessary, the fi lter can also be
washed in warm water without any additives. Place it
back into place only once it is completely dry!
30.08.2005, 15:45:10 Uhr