Safety Instructions; General Safety - Dometic WAECO ColdMachine 54 Notice D'utilisation

Safety instructions

➤ Action: this symbol indicates that action is required on your part.
The required action is described step-by-step.
✓ This symbol indicates the result of an action.
Fig. 2 1, page 3: This refers to an element in an illustration. In his case,
item 1 in figure 2 on page 3.
Please observe the following safety instructions.
2 Safety instructions
Caution!
a
Dometic WAECO International will not be held liable for claims for
damage resulting from the following:
– Installation errors,
– Damage to the device resulting from mechanical influences
and overvoltage,
– Alterations to the device made without the explicit permission
of Dometic WAECO International,
– Use for purposes other than those described in the operating
manual.
2.1

General safety

Have a trained technician make installations in wet rooms.
a
Do not operate the device if it is visibly damaged.
This device may only be repaired by qualified personnel.
Inadequate repairs can lead to considerable hazards.
Should your device need to be repaired, please contact
WAECO customer services.
Do not open the refrigerant circuit under any circumstances. An
exception to this is when the device has to be disconnected for
return shipping (chapter "Installing the external temperature
regulator" on page 43).
Set up the device in a dry location where it is protected against
splashing water.
Do not place the device near naked flames or other heat
sources (heaters, direct sunlight, gas ovens etc.).
Make sure that the compressor is sufficiently ventilated.
36
ColdMachine