Beko WMD 66160 Mode D'emploi page 11

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

6 Solution suggestions for problems
Problem
Cause
Machine may have switched to
Program cannot be
self protection mode due to an
started or selected.
infrastructure problem (such as
line voltage, water pressure, etc.).
There is water
coming from the
There might be problems with
bottom of the
hoses or the pump filter.
machine.
Machine stopped
Machine can stop temporarily
shortly after the
due to low voltage.
program started.
It continuously
spins.
There may be an imbalance of
Remaining time
laundry in the machine.
does not count
down.
In the case of a paused
countdown while taking in water:
Timer will not countdown until the
machine is filled with the correct
amount of water.
In the case of a paused
countdown at the heating step:
Time will not count down until
the selected temperature for the
It continuously
program is reached
washes.
Remaining time
does not count
down.
In the case of a paused
countdown at the spinning step:
There may be an imbalance of
laundry in the machine.
Explanation / Suggestion
Reset your machine by pressing "Start/Pause/Cancel"
button for 3 seconds. (see, Canceling a Program)
Be sure the seals of the water inlet hoses are securely
fitted.
Tightly attach the drain hose to the tap.
Make sure that the pump filter is completely closed.
It will resume operating when the voltage is back to the
normal level.
The automatic spin correction system might have been
activated due to the unbalanced distribution of the
laundry in the drum.
The laundry in the drum may be clustered (bundled
laundry in a bag). Laundry should be rearranged and
re-spun.
No spinning is performed when the laundry is not evenly
distributed in the drum to prevent any damage to the
machine and to its environment.
The machine will wait until there is a sufficient amount of
water to avoid poor washing results due to lack of water.
Then the timer will start to count down.
The automatic spin correction system might have been
activated due to the unbalanced distribution of the
laundry in the drum.
The laundry in the drum may be clustered (bundled
laundry in a bag). Laundry should be rearranged and
re-spun.
No spinning is performed when the laundry is not evenly
distributed in the drum to prevent any damage to the
machine and to its environment.
11 - EN

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Wmd 66140 sWmd 66140Wmd 66120 sWmd 66120

Table des Matières