Slendertone CoreFit Mode D'emploi page 7

Step 3 – Attach controller and remove the covers.
i) Attach the controller to the belt ensuring you align the magnetic connectors on the rear of the controller to
those on the holster, as shown in Fig. d.
Fig. d
ii) Remove the plastic covers from the black side of all three GelPads as shown in Fig. e. Do not throw these
plastic covers away as you will need to put them back onto the GelPads at the end of the session.
Fig. e
Step 4 - Position the belt on your body.
Wrap the belt around your waist so that the GelPads are pressed firmly against your skin, positioning the large
square GelPad over your navel (belly button). Stretch the ends of the belt around your waist until the small
GelPads are between your hip bone and ribs. Fasten the belt tightly around your waist, but not so tight as to
cause discomfort. See Fig. f.
Fig. f
N : You can adjust the belt for a smaller waist size by folding over the left end and securing it with the additional
OTE
Velcro tab. Then securely fasten the belt around your waist as normal.
7