Product Care - Slendertone CoreFit Mode D'emploi

PRODUCT CARE

Caring For Your Belt
Your belt may be cleaned using a lightly dampened cloth, but you must first remove the controller and GelPads.
Always follow the instructions on the label when washing the belt.
In order to protect the internal wiring from damage, do not hand wash or machine wash your belt.
Do not use bleach when washing the belt.
Do not dry clean your belt.
Do not tumble dry your belt. Dry the belt on a flat surface. Do not dry it over anything hot. (e.g. a
radiator) as the belt contains plastic parts. Ensure the belt is completely dry before using it again.
The belt should not be ironed.
Belt Materials:
Outer material: 87% Nylon 13% Elastane; Hook & Loop: 100% Nylon; Inner Foam: 100% Polyurethane;
Textured Panel: 70% Polyurethane, 30% Polyester.
Caring For Your Controller
• Your
SLENDERTONE COREFIT
cleaned using a soft, lightly dampened cloth. Do not allow the interior of your controller to become wet. Do not
use detergents, alcohol, spray aerosols or strong solvents on your controller. If your controller is damaged, you
should not use it but you should contact the
and modifications may not be carried out by anyone other than qualified service personnel authorised by
.
SLENDERTONE
• Access to the interior of the controller is not required for maintenance purposes. The battery is not accessible
or replaceable.
• Do not try to open your controller casing or alter in product in any way that could cause harm to individuals.
Tampering with the product would also invalidate the warranty.
Caring For Your GelPads
• The GelPads are for single person use only.
• The durability and effectiveness of the GelPads depends entirely on their use, storage and care. Certain skin
types, the duration, number of sessions, intensity used and area of stimulation can also affect the life of the
GelPads.
• Ensure your hands are clean before handling GelPads. You should avoid touching the black side of the
GelPads with your fingers as much as possible when applying or removing the belt, as this can transfer oils
and skin particles onto the GelPads' surface.
• After use, replace the liners on the black side of the GelPads and store your product in a cool, dry place until
the next use.
• GelPads will need to be replaced periodically as the surface picks up skin debris and become dry over time.
• Do not use the GelPads if they are pierced or torn.
Rated Outputs – Voltage/Currents: Type 734
Parameter
Output RMSV
Output RMSA
Output Frequency
DC Component: Approx.
Positive Pulse Width:
Negative Pulse Width:
Interphase Interval:
12
controller should not be allowed to get wet or be left in excessive sunlight. It may be
SLENDERTONE
500
7.35V
14.7mA
50-70Hz
0 C
200-315µs
200-315µs
100µs
customer care helpline for advice. Repairs, service
1K 1K5
13.1V 15.5V
13.1mA 10.3mA
50-70Hz 50-70Hz
0 C 0 C
200-315µs 200-315µs
200-315µs 200-315µs
100µs 100µs