Unpacking The Generator; Overview Of The Equipment - Parker domnick hunter G1 Guide D'utilisation

G1 - G9
2.2

Unpacking the Generator

Remove the equipment from its packaging as shown below and check that it
has not been damaged in transit.
This generator is heavy and must not be manually lifted.
Warning
The following items have been included with your equipment:
MIST-X Drain Kit (G4 Models Only)
Swagelok fittings
Mains supply cables
If any items are missing or damaged please contact your local domnick hunter
office.
2.3

Overview of the equipment

1
n n
DOMNICK HUNTER LTD. DOMNICK HUNTER LTD.
2
4
4b
4a
The G4 generator must not be allowed to run and flow to atmosphere via the N2 Outlet.
An external mass flow controller must always be used and set to the maximum outlet flow of the generator.
Caution
Description
3
4
WARNING WARNING
LIVE TERMINALS LIVE TERMINALS
ENCLOSED ENCLOSED
DISCONNECT THE DISCONNECT THE
MAINS SUPPLY BEFORE MAINS SUPPLY BEFORE WARNING WARNING
REMOVING THIS COVER REMOVING THIS COVER
GENERATOR MUST BE SHUT GENERATOR MUST BE SHUT
DOWN AND DEPRESSURISED DOWN AND DEPRESSURISED
BEFORE PERFORMING BEFORE PERFORMING
ANY MAINTENANCE ANY MAINTENANCE (REFER TO MANUAL) (REFER TO MANUAL)
DANGER DANGER
DISCONNECT THE DISCONNECT THE
MAINS SUPPLY BEFORE MAINS SUPPLY BEFORE
REMOVING THIS COVER REMOVING THIS COVER
4c 4e
4d
Key:
1 Controller
2 Lower service hatch
3 Upper service hatch
4 Pressure gauges and regulators (where fitted)
a Air pressure regulator
FUSE FUSE
230V.AC 230V.AC 2A"T"HBC 2A"T"HBC
5x20mm 5x20mm
b Air receiver pressure gauge
c Air outlet pressure gauge
NITROGEN (N2) NITROGEN (N2) d Inlet air pressure gauge
NITROX NITROX
DO NOT BREATHE DO NOT BREATHE MAX PRESSURE MAX PRESSURE
10barg(145psi) 10barg(145psi)
NON-FLAMMABLE NON-FLAMMABLE COMPRESSED COMPRESSED
GAS GAS USE ONLY WITH USE ONLY WITH
EQUIPMENT COMPATIBLE EQUIPMENT COMPATIBLE WITH THIS PRESSURE WITH THIS PRESSURE Dukesway, Team Valley Trading Estate, Dukesway, Team Valley Trading Estate,
Gateshead, Tyne and Wear, England NE11 0PZ Gateshead, Tyne and Wear, England NE11 0PZ
Tel.+44(0)191 4029000 Fax.+44(0)191 4971216 Tel.+44(0)191 4029000 Fax.+44(0)191 4971216
5 PROCESS CONTROL EQUIPMENT 2SD7 PROCESS CONTROL EQUIPMENT 2SD7 LISTED LISTED
e N2 outlet pressure gauge
f
g N2 Pressure regulator
5 Inlet / Outlet connections
4f
4g
6
DOMNICK HUNTER LTD.
N2 receiver pressure gauge
Electrical Supply Inlet. (Label
indicates supply voltage and fuse
FUSE
230V.AC
2A T HBC
5x20mm
rating)
Air inlet port
(All option 0 generators)
Air MFC Outlet
(G6, G7, G8 and G9 models only)
Mass Flow Control outlet
(All Models except G8 and G9)
N2 outlet port*
(G4 Models only)
Drain
(G4 Models only)