Esscom PL-1085 Mode D'emploi page 41

PL-1085
remote devices found, the type of logical network (Public or Private), and a
message area that reports the connectivity and scan status.
The following information is displayed for each device discovered :
• Device Name : shows the default device name. You can change the name
by clicking the name, or by using the Rename button.
An icon is optionally shown with the name. A distinction in icons is made
between low-speed and high-speed devices (14 Mbps or 85 Mbps devices)
• Password : shows the user-supplied device password (initially left blank).
You can enter the password by using the Enter Password button.
To enter the Password of the device (required when creating a private net-
work), first select the device by clicking on its name in the lower panel and
then click on the Enter Password button.
Above dialog box will appear.
The selected device name is shown. Now enter the password. (The password
is located at the bottom label of the device). Click OK to confirm the password.
A confirmation box will appear if the password was entered correctly.
The Add button is used to add a remote device to your network that is not on
the displayed list in the lower panel. For example a device currently on another
logical network.
41