Using The Wrist Strap; Reclining The Seat; Positioning The Canopy; Adjusting Handle Position - B.O.B REVOLUTION FLEX 3.0 Mode D'emploi

Masquer les pouces Voir aussi pour REVOLUTION FLEX 3.0:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

BOB Gear
5� Adjust Shoulder Straps
Open pads with hook and loop
fasteners. Slide buckle up or
down to adjust straps. Seat
harness should fit snug and be
comfortable.
6� Tighten Lap Strap
Adjust lap strap to fit snug and be
comfortable.
Lap Strap
Avoid serious injury from falling
or sliding out� Always use
harness to secure child�

Using the Wrist Strap

1� Slip Loop of Strap Securely
Onto Wrist
The wrist strap is designed to
help prevent the stroller from
rolling away should you lose your
grip on the stroller. When using
the stroller, make sure the strap is
securely looped over your wrist.
12

Reclining the Seat

IMPORTANT:
Set parking
brake before making any seat
adjustments.
1� Recline Seat
Squeeze the recline button and
pull the seat back down into the
desired position.
2� Return To Upright Position
Grab the rings on either side of
the recline button and pull the
straps out to the sides to raise the
seat.
When seat is fully reclined,
backward tip-over is more
likely, and may result in injury
to stroller occupant�

Positioning the Canopy

1� Extend Canopy
Rotate canopy away from
handlebar for additional shade.
2� Retract Canopy
Push canopy toward handlebar.

Adjusting Handle Position

To adjust the handle position,
depress and hold the two release
buttons on the inside of the handle
assembly while raising or lowering
the handle to one of the individual
positions.
REVOLUTION FLEX 3.0 User Guide

Using the Accessory Adapter

This BOB stroller is equipped with
an accessory adapter providing
easy attachment for BOB Stroller
accessories like the snack tray or
infant car seat adapter.

Care and Maintenance

Check tire pressure before
every use�

Regular Inspections

Before each use, check this stroller
and its components to make sure
they are in good condition and good
working order.
• Verify tire pressure.
• Verify all screws, attachment
points and fasteners are tight.
• Check all wheels to be sure they
are secure.
• Check for tears or excessive wear
in the fabric.

Cleaning

The fabric has a stain resistant
treatment that makes most cleanups
easy.
• Use a sponge with a solution
of mild soap and cold water
(maximum temperature of 100˚ F /
38˚ C).
• Rinse thoroughly with clean water
to remove soap, then air dry.
• Do not use detergent or abrasive
cleansers.
• Do not pressure wash.
13

Publicité

Table des Matières
loading

Table des Matières