Basic Disc / Usb Operation; Start Playback - Furrion DV3350 Manuel D'instructions

Operation
Use the / APS button
In radio mode:
1. Press and hold
APS on the remote control) to search
for radio frequencies with sufficient
signal strength (starting from the lowest
frequency and ending until the search
cycle is finished).
Then the 6 strongest stations are preset
to the memory bank of the corresponding
preset number. The AS operation is
implemented in each bank of the selected
band. When the AS operation is finished,
radio broadcast will resume on M1. (A total
of 3x6 stations for FM and 2x6 stations for
AM can be stored.)
2. Press on the front panel (or APS on the
remote control) to search for each preset
radio station starting from M1. When the
field strength level is above the threshold
of the stop level, the radio holds at that
preset number for a few seconds, and
then searches again. The search stops on
M1 when the search cycle is finished.
NOTE:
On FM band, FM1, FM2, FM3 is checked
–
once at a time.
On AM band, AM1, AM2 is checked once
–
at a time.
Use the preset number button (1-6)
In radio mode:
1. To store the current frequency on the
current band, press and hold any one of
the six preset number buttons (1-6).
2. To recall the preset memory on the
current band, press one of the preset
buttons [1-6].
Switch between STEREO/MONO
on the front panel (or ST on the
Press
SEL
EQ
remote control) once or more to select ST ON
or ST OFF mode in FM mode.
19
on the front panel (or
Use the LOC ON / OFF function
1. In radio mode, when the signals of the
distant radio stations are very weak and
the reception is poor during tuning, press
on the front panel (or LOC on the
SEL
EQ
remote control) once or more to select
LOC OFF mode, and then tune again for
the distant radio stations.
2. In radio mode, too strong signals from
the local radio stations may lead to
interference. You can press
front panel (or LOC on the remote control)
once or more to select LOC ON mode,
and then re-tune to the local stations if
required.

Basic Disc / USB Operation

Start playback

1. Press to turn on the unit.
2. Turn on the TV set, from which the video
output is connected to the video input of
the unit.
● If nothing displays on the TV screen
when the unit is turned on, ensure that
the TV is set to the right video input (not
TV channel). For example, if the TV is
connected with the unit via the VIDEO
1 INPUT, then you need to set the TV to
VIDEO1.
3. Insert a disc into the disc slot (with the
label side facing up).
NOTE:
Discs that are seriously scratched or of
–
poor manufacturing or recording quality
may not play.
If the unit cannot read a disc in normal
–
conditions, please try to eject and reload
the disc.
In addition to normal CD and DVD, this
–
unit supports CD-R, CD-R/W, DVD-R and
DVD-R/W playback as well. However,
depending on the conditions of the
on the
SEL
EQ