Installing The Unit - Furrion DV3350 Manuel D'instructions

Before Operation
Location
1. Choose a mounting location away from humid areas, water sources, appliances or any
equipment that can radiate heat.
2. Select an area on a wall or cabinet which is free from cable, fuel or brake lines. Ensure the
area behind the unit has a vent hole or if it is an enclosed box, it has adequate room around
the rear of the unit for cooling.
3. Ensure when the unit is mounted the wires at the rear are not pressed against the heat sink.

Installing the unit

● Before final installation, check by powering the stereo on to make sure unit operates
properly.
● Please connect according to following diagram for proper functionality.
1. Remove top and bottom front panels.
2. Slide the device into a prepared opening and fix with 4 #8 pan head self-tapping screws.
3. Reattach the top and bottom front panels and push slightly until it locks into place.
SCREW
13
SCREW
FRONT PANEL(TOP)
FRONT PANEL(BOTTOM)