Installing The Plastic Wedges; Electrical Connection - Grundig GFN 13840 XN Manuel D'utilisation

•
Your product requires adequate
air circulation to function
efficiently. If the product will be
placed in an alcove, remember
to leave at least 5 cm clearance
between the product and the
ceiling, rear wall and the side
walls.
•
If the product will be placed in
an alcove, remember to leave at
least 5 cm clearance between
the product and the ceiling,
rear wall and the side walls.
Check if the rear wall clearance
protection component is present
at its location (if provided with
the product). If the component
is not available, or if it is lost
or fallen, position the product
so that at least 5 cm clearance
shall be left between the rear
surface of the product and the
wall of the room. The clearance
at the rear is important for
efficient operation of the
product.
If two coolers are to be
installed side by side,
C
there should be at least
4 cm distance between
them.
12
3.2 Installing the
plastic wedges
Plastic wedges are used to create
the distance for the air circulation
between the product and the rear
wall. Insert the 2 plastic wedges
onto the rear ventilation cover as
illustrated in the figure. To install
the wedges, remove the screws
on the product and use the screws
given in the same pouch with the
wedges.

3.3 Electrical connection

Connect the product to a grounded
outlet protected by a fuse
complying with the values in the
rating plate. Our company shall
not be liable for any damages that
will arise when the product is used
without grounding in accordance
with the local regulations.
•
Electrical connection
must comply with national
regulations.
•
Power cable plug must be within
easy reach after installation.
•
The voltage and allowed fuse or
breaker protection are specified
in the Rating Plate which is
affixed to interior of the product.
If the current value of the fuse
or breaker in the house does