ENERMAX Platimax EPM1050EWT Manuel D'utilisateur page 7

CONNECTOR TYPES
24P Mainboard
For new generations of ATX/EEB/CEB server/workstation MB.
8P CPU +12V
8-pin configuration supports multi-CPU server/workstation systems and some
single extreme CPU systems.
4P CPU +12V
4-pin configuration supports certain single CPU systems.
6+2P (8P) PCI Express, in combined mode
8-pin configuration supports latest extreme graphic cards, which require 8-pin
PCI-E connector.
6+2P (8P) PCI Express, in split mode / 6P PCI Express
6-pin configuration supports most performance PCI-E graphic cards, which require
6-pin PCI-E connector.
SATA
For SATA/SAS drives.
4P Molex
For IDE/SCSI/SAS drives or some AGP graphic card with traditional 4P power in
socket.
FDD
For floppy drive or certain add-on card.
#1 Some SATA drives might accept SATA or 4P Molex power. Normally, use either one of power
connector to power the driver, BUT NOT BOTH! Please check the drive's manual for details.
#2 Some MB might require this connector to share the +12V current from 24-pin Mainboard connector to
PCI-E slot. If your system has multiple extreme graphic cards, please plug this connector to MB
correspond socket and check the MB's manual for details.
MODULAR CABLES SUPPLIED
Use ONLY genuine ENERMAX modular cables coming with ENERMAX PSU. Third party cables
might not be compatible and might cause damage to your PSU and/or system, and use of third party
cable shall void PSU warranty.
# 1
# 2
EMC014-G: 2 x 6+2P (8P) PCI-E 2.0
Modular cable for 1 or 2 performance PCI Express graphic cards, which
needs 6P or 8P PCI-E connector.
EMC018-G : 8P & 4P +12V CPU/RAM power
Modular cable to support special heavy-duty workstation/server with more
than 4 CPUs and 16 RAMs.
EMC019-G: 4 x SATA drives
Modular cable for SATA/SAS drives like ODD and HDD.
EMC020-G : 4 x 4P Molex (IDE/SCSI) drives & 1 x FDD connector
Modular cable for IDE/SCSI/SAS drives and peripheral, plus 1 FDD power
connector.
5