Replacing The Oven Lamp - Fulgor Milano FCSO 4510 TEM Instructions Pour L'installation Et L'utilisation

IMPORTANT
The oven lamp must have precise characteristics:
a) Structure suitable for high temperatures (up to 300 °C);
b) Power supply: see the V/Hz value on the serial number
plate;
c) power 25 W;
d) Type G9 connector.
Attention: make sure the appliance is off before replacing the
lamp to avoid the possibility of electric shock.
• To avoid damage, spread a tea towel for pots and pans
inside the oven;
• Remove the screws holding the steel frame;
• Remove the old lamp by sliding it out of its seat and taking
care not to break it;
• Insert the new bulb taking care not to touch it with your hands
(we recommend using a disposable latex glove);
• Replace the stainless steel frame taking care not to pinch the
silicone gasket seal;
• Screw in the stainless steel screws you previously removed
• Connect the appliance to the power line.

18 - Replacing the oven Lamp

EN
25