General Recommendations; Hose Assembly - Mato 35 543 54 Notice D'utilisation

E
The hose reels are available in 4 versions for oil, grease, water, air respectively.
When configuration has been chosen it can only be used for that particular liquid.
The hose reel consists of a rotary drum controlled by a spring which can rewind the hose after it has been taken
out.
The seal is secured by a special rotating joint.
The bracket R locks inlet pipe avoiding twisting.
A hose stop fitted on the outlet pipe allows the adjustment of the hose ( it is advisable not to leave more than 4
meters of hose out when the hose reel is not in use).
The hose reels can be installed on the ceiling ( maximum height 4 meters), on the wall or on the ground if
required.
•
Please read the following handbook before use.
•
Use the hose reel only for the purpose of its original design
•
It is not suitable for delivery of corrosive or inflammable liquids.
•
Do not modify any component of the hose reel in order not to compromise the safety of users and the
validity of the guarantee.
•
Any repairs must be carried out with original spare parts only.
For safety reasons users must only carry out routine maintenance ( See maintenance section), whereas
for repair or replacement of components it is necessary to contact manufacturer.
•
Installation must be carried out by authorised personnel.
•
In order to avoid damage to people and objects close to the hose reel it is necessary to hold the delivery gun
until the hose has been completely rewound by the reel.
For any application which is not mentioned in the handbook please contact our technical department
•
Select hose according to type of liquid, dimension and maximum pressure indicated on the label.
•
Position hose reel on a suitable worktop.
•
WARNING: Make sure that spring is not under tension.
•
Remove the plastic cover C.
•
Insert hose through outlet rollers, slip it through the hole on the drum and screw the end pipe fitting to the
fitting linked to the shaft.
•
Put plastic cover C back on .
•
Insert appropriate key (socket head screw 10) in the support S and rewind counterclockwise the hose on the
drum.
•
Take the two shell stops L, select the rubber reduction gasket M ( marked with 1-2-3 numbers) which fits
the hose diameter and secure everything to the hose with screws H and nuts I leaving out the necessary
hose to apply delivery gun.
•
When the hose has been rewound it is necessary to adjust the spring tension as follows:
WARNING : This operation must be carried out by qualified staff.
1.
2.
3.
4.
•
Install the hose reel ( see INSTALLATION section )
Description

General recommendations

which will be available to give further information.

Hose assembly

Insert suitable key ( ram ½ ") in the square hole of the support S.
Unscrew screws T which fasten the support.
Hold key firmly and rotate the support clockwise for 3-5 turns.
Hold key firmly and screw screws T back on the support.
Uses
11