Bionaire BOH1501 Manuel D'utilisation page 3

BOH1501-I_IB_REV.qxd:BPH1515I06MLM1.qxd 3/19/09 11:55 AM
ENGLISH
PLEASE READ AND SAVE THESE
IMPORTANT INSTRUCTIONS
WARNING: In order to avoid overheating,
do not cover the heater ( ) Reference to
product.
DO NOT
DO NOT
DESCRIPTIONS (See Fig. 1, 2 & 3)
DO NOT
DO NOT
DO NOT
Technical Specifications
BOH1501/W
BOH2001/W
DO NOT
ASSEMBLY INSTRUCTIONS (See Fig. 3)
DO NOT
Please make sure the heater has not been
plugged into any electricity outlet.
DO NOT
Note:
This unit is for FLOOR USE ONLY.
DO NOT
Page 2
OPERATING INSTRUCTIONS
(See Fig. 1&2)
NOTE: When the heater is in use, it is
normal that the heater cycles ON and OFF,
this is to maintain your desired temperature.
BOH1501/W
BOH2001/W
SETTING THE THERMOSTAT
NOTE: The Power light will remain lit during
operation.
NOTE: It is normal for the heater to cycle ON
and OFF as it maintains the preset
temperature.
ANTI-FROST GUARD INSTRUCTION
NOTE: Unit must be unplugged for it to be
fully off
TIP OVER PROTECTION
STORAGE TIPS
FITTING A REPLACEMENT PLUG FOR
U.K. AND IRELAND ONLY.
INSTALLATION OF A PLUG – Applicable to
U.K. and Ireland.
NOTE: If you are in any doubt about wiring
and the installation of the plug. Please
contact a qualified electrician.
NOTE: If a 13A 3-pin plug is fitted, it must be
an ASTA approved plug, conforming to the
BS1363 standard. Replacement 13 amp fuse
must also be BSI or ASTA approved.