HWAM 3120 Guide D'installation page 7

a i
sseMbly nstructions for coMbustion air systeM
Fresh air connection through the rear plate (drawing A):
1. Lift the cast-iron top (1) off the stove.
2. Remove the two sides of the stove by loosening the screw (2) and removing it. The two screws
(3) should only be loosened (not removed). Lift the sides off.
3. Make sure the cover plate (4) is placed on the down-facing connector bush on the air box (5).
4. Loosely attach the clamp (6) to the rear-facing connector bush on the air box (7).
5. Pull the insulation sleeve (8) approx. halfway onto the flexi-hose (9).
6. Lead the flexi-hose beneath the wires and attach it to the rear-facing connector bush on the air
box (7). Tighten the clamp (via the wood section), until it is no longer possible to turn the flexi-
hose (use a ratchet spanner, as this is easier to work with, and be careful not to over tighten the
clamp, thereby deforming the air box connector bush).
7. Pull the insulation sleeve all the way onto the flexi-hose until it sits tight against the rear plate.
8. If needed, the insulation sleeve can be attached with a cable fastener (10).
9. Remove the plate (11) in the bottom of each of the stove sides by tapping on in with a soft
hammer. This makes room for the flexi-hose.
10. Place the sides on the guide pins (12) and hang on the screws (3) which must be fastened again.
11. Place the cast-iron top (1) on the stove.
Fresh air connection through the bottom plate (drawing B):
1. Make sure the cover plate (1) is placed on the rear-facing connector bush on the air box (2).
2. Pull the insulation sleeve (3) onto the flexi-hose (4).
3. Remove the pre-cut plate (5) in the bottom plate of the stove by tapping on it with a soft hammer
and lead the flexi-hose through the opening.
4. Place the flexi-hose on the downward-facing connector bush of the air box (6) and tighten it with
the clamp (7). Tighten the clamp (via the wood section), until it is no longer possible to turn the
flexi-hose (use a ratchet spanner, as this is easier to work with, and be careful not to over tighten
the clamp, thereby deforming the air box connector bush).
5. Pull the insulation sleeve all the way up to the connector bush and fasten it with the cable fastener
(8). Be careful not to over tighten.
7
e
nglish