Dynex DX-E402 Guide De L'utilisateur page 16

16
If the result displayed is similar to what is shown in this example, your computer has
not connected to your router. If so, refer to the following for a solution.
Is the connection between your computer and your router correct?
Is the TCP/IP configuration for your computer correct?
I'm an ADSL user. How do I configure my router to access the Internet?
To configure your router to access the Internet:
1 Configure the ADSL modem to the RFC1483, or similar, bridge model.
2 Connect the Ethernet cable from your ADSL modem to the WAN port on your router.
The telephone cord plugs into the Line port of the ADSL modem.
3 Log in to your router, click Network on the left of your browser, then click WAN. The
WAN page opens.
4 On the WAN page, select PPPoE for WAN Connection Type. Enter the user name
password, then click Connect. The Internet Connection Mode page opens.
5 If Time-based Connecting is checked, select Connect on Demand or Connect
Manually for Internet connection mode. Type an appropriate number for Max Idle
Time to avoid wasting paid time. Otherwise, you can select Auto-connecting for
Internet connection mode.
The Link/Act LEDs of the LAN port on your router and LEDs on your computer's
network adapter should be lit.
If your router's IP address is 192.168.1.1, your computer's IP address must be within
the range of 192.168.1.2 ~ 192.168.1.254, and the gateway must be 192.168.1.1
Appendix - FAQ