Getting Started; Setting The Device - Sanitas SFT 65 Mode D'emploi

4

Getting started

The batteries are already inserted in all new devices. Before first use, remove the protruding plastic insulating strip from
the battery compartment. The thermometer will then switch on automatically.
5

Setting the device

Set the unit in which the temperature will be displayed, the date and the time
8 8 8
88:88
When the thermometer is used for the first time, and each time the batteries are changed, the date and time are dis-
played in the format
be displayed, the date and the time. To set the device, proceed in stages: unit – year – month – day – hours – minutes.
• Press the button for approx. 3 second to access the Set mode.
The setting to be changed will flash in turn.
• Press the button again to save the setting or
• press the button to change the setting.
• Then press the button to save the setting.
After this process, the thermometer shows the word
Press the button for 1 second to switch the thermometer on. The device performs
a brief self test: all elements of the display are shown for approx. 1 second. Following
a successful self test, the device emits two short beeps. In Standby mode, the date
8
and time are shown and " " is displayed.
during the basic set-up (after the self test). Now set the unit in which the temperature will
in the display and switches off automatically.
23