Nice 1.2 Instructions De Montage page 9

this operation.
24. Before it cools down, position the handrail A02 on the balusters C03 starting from the top (Fig. 7).
25. Drill the handrail A02 in correspondence to the holes in the end part of the baluster BE3 using a 5 mm Ø bit and
fix using the parts B54 and B55.
26. In quick succession, fit the balusters
that they are vertical. Tighten the part B02 and fasten the balusters to the handrail A02 using the parts B54
and B55.
27. Cut the excess handrail A02 in correspondence to the first baluster C03 of the staircase.
28. Complete the handrail A02 by fixing the parts A03 using glue X01 (Fig. 1).
29. Join the end part of the railing to the section of the balustrade on the landing E04 using the appropriate fixture
obtained by assembling the parts A20, A03, C92 and B08 (Fig. 9).
30. Join the fixture obtained to the handrail A02 using the screws C87 after drilling the holes underneath the
handrail using a 2.5 mm Ø bit (Fig. 9).
31. To complete the balustrade on the landing E04, position the parts F01 using the parts C89 and B02. Drill
the landing E04 using a 5 mm Ø bit, keeping the distance between the holes the same as that between
the balusters C03 of the railing assembled previously. Fit the balusters C03 (H. 935 mm) to the parts F01
positioned on the landing E04. Position the handrail A18 on the balusters and drill in correspondence to the
holes in the end part BE3 of the baluster using a 5 mm Ø bit and fasten the parts B54 and B55. Complete the
handrail A18 by fixing the parts A03 using glue X01 (Fig. 1).
32. Complete railing assembly by fitting the parts B82 to the lower part of the balusters C03 (Fig.1).
Final assembly
33. To further stiffen the staircase at intermediate points, fasten the parts F09 on the wall and join them to the
balusters C03 using the parts F08. Drill using an 8 mm Ø bit and use the parts C50, C49, C90, B12 (Fig. 10).
NICE_12_150.indd 9
C03 (H. 1060 cm) and C03 (H. 1130 mm) to the part F23 making sure
9 - NICE 1.2 Ø 150 cm
29/04/15 10.56