Burg Wächter LASER METER 20 PS 7520 Mode D'emploi page 22

Measuring surfaces
With the device turned on, press the button
once to select measuring a surface. The symbol for
surface measurement
the first distance of the surface flashes. Target the
end of the about to be measured distance and press
the measurement button
measurement. The measured value appears on the top
display line while the second distance of the surface
flashes. With the laser, target the end of the next
distance and press the measurement button to perform
a second measuring. The second measured value will
be displayed in the second line. Simultaneously, the
resulting surface is being calculated and is shown in
the bottom line of the display. The circumference of
the measured surface is additionally listed in the third
display line.
If you want to delete one of the measured lengths
during measuring a surface, press the button
once. Afterwards, you can proceed with the
CLEAR
measuring as before.
24 | English
appears on the display,
once to perform the
MEAS
First distance
Second distance
Circumference
Surface
LASER METER 20 PS 7520