Num'axes CANICOM 5.500 LE Guide D'utilisation page 26

Programming the
- Activate the remote control
- Select the collar Nr 1
-
- Press the button for approximately 5 seconds until the stimulation level flashes on the LCD screen
-
+
- Press the or
- Press the button to confirm the level selected
If you have several collars, renew the same procedure for each one.
-
+
●
and buttons: stimulation level control buttons
-
+
Use the and buttons for rapid adjustment of the level of stimulation of the receiver collar.
25 levels of stimulation are available.
Level 1: very weak stimulation – Level 25: strong stimulation
Always start with the lowest level of stimulation.
● Back-lightning of the LCD screen
You can light the LCD screen for approximately 6 seconds by pressing briefly the On/Off button
control (approx. ½ second).
● Checking/replacing battery of the remote control
To check the condition of the battery, activate the remote control and look at the battery
level indicator on the LCD screen.
Performance (radio range) of the remote control may deteriorate as battery becomes weak.
Be prepared to replace battery.
Diagram 7 - Replacing the battery in the remote control
WARNING: Make sure the polarity is correct.
button for the collar Nr 1 (collar with black strap):
button to modify the stimulation level
Gb - 26
of the remote