HQ PowerKites CrossFIRE 2 Mode D'emploi page 7

The safety system kite-killer
The safety system (kite killer) makes it
possible for you to release the handles in
dangerous situations without losing your
kite. HQ recommended to try out this func-
tion several times so your reflexes will be
formed, and you will gain confidence with
this maneuver
We recommend the use of this
system!
In order to use it, fasten the left and right
strap around the respective wrist. Do not
fasten it too loosely, in order to prevent
slipping over the hand. Now you can release
the handles during the flight. The System
will activate the brakelines and depower the
kite. Then the kite will land.
Larks Head
Knot
Start
The possible flight area of a kite or parafoil
is called the wind window.
The wind provides the greatest pulling force
at the center of the wind window. The pull
drops off at the edges. The park and initial
position for use is located directly above the
pilot in the zenith.
Zenith
Launch and land
here if there is a lot
of wind
When launching, the foil is flown from the
ground in the center of the wind window
up into the zenith. The foil almost reaches
its maximum pulling force during this flight
into the zenith. Therefore, before launching,
check that the lines are laid correctly accor-
ding to the wind direction and that the
foil size was chosen correctly for the wind
strength.
The handles are held at their upper ends,
directly below where the power lines feed
in. The brake lines (below) hang through
loosely. To launch the foil, pull on both
handles simultaneously. If the wind is light
to moderate, take a step backwards and
pull hard. The foil lifts from the ground and
flies directly upward into the zenith. Correct
deviations in the flight path by controlling
the kite (see section on controlling)
The foil can carefully be launched on the
side edge of the wind window if there is a
strong wind for the selected foil size. To do
this, a helper should secure the foil. The
build-up of foil pull is significantly less,
which means a safer launch and less stress
on the material.
Power zone
7