Guarantee Conditions - Weka 606.3050.30.00 Notice De Montage, D'utilisation Et D'entretien

GUARANTEE CONDITIONS

weka Holzbau GmbH provides you with a 5-year guarantee for design and processing quality. Within
the guarantee time, faulty parts will be replaced free of charge. Costs arising as a result of the
exchange are not included in the guarantee claim.
Guarantee claims may only be made in conjunction with the original packing list and proof of
purchase.
Excluded from the guarantee are defects caused by:

improper subsoil and foundations

assembly not carried out in accordance with these instructions

your own alterations to the product

defective care in the maintenance of the current wood quality

prevailing winds in excess of force 7 (stiff wind)
Inland, consequences such as the movement of whole trees and any noticeable
impedance when walking in the open air are to be observed. No defects due to
these conditions will give rise to a guarantee.
Natural catastrophes or other violent occurrences.
Fluctuations in colour, crack formation, warping or similar changes which are completely
normal outdoors are no grounds for making a claim.
Further claims and consequential damage do not fall under the guarantee regulations. Our General
Terms and Conditions apply.
NOTES – ROOF TILES

Prior to mounting, the roof tiles are to be stored undercover and out of direct sunlight. This applies
in particular to white foils. Heat may build up under a stack of tiles leading to distortion and
discoloration of the tiles due to the burning glass effect.

Roof tiles must not be mounted in temperatures below +5°C or above 30°C.

In order to guarantee the impermeability of your car port, silicon is to be used when laying the roof
tiles (not included in the delivery), see page 21.

The roof tiles are to be pre-drilled with holes with a diameter = 8 mm.

Please note that the tiles are to be screwed into place on the front and back purlin on every 2nd
wave, on the centre purlins on every 3rd wave. Figure page 21

Use the spacers (item 16) according to the figure on page 21.

Please note that the screws are not to be screwed down too tightly in order to guarantee the
function of the tiles.

Note: No false floor may be installed or thermal insulation provided below the roof tiles. There
must be adequate ventilation beneath the roof tiles.
TOOL
You should have the following tools to hand before beginning assembly. (Not supplied.)
Spring tape measure
Drill
Spanner
Techn. Änderungen vorbehalten!
Spirit level
Electric screwdriver
Silicone
Alle Maßangaben sind ca. Maße.
6
Pencil Mitre saw/hand disk saw
Taper drill
= Entrance
 Copyright HRB 3662
Screw clamp