(Gb) Instructions - Titan UR 2300 Notice D'emploi

(GB) Instructions
everything is correct, light will be visible when a
button is pressed.
Adapting to Appliances
In order to control your appliances you must ad-
apt or set the remote control to them. There are
three ways of doing so:
Direct control code entry
Example: Setting to control a Philips televi-
sion set:
1 The attached list gives, for example, the
Philips Code 0099.
Vivanco GmnH, D-22926 Ahrensnurg, E-Mail: hotline@vivanco.de, Helpline: +49 (0) 4102 231135
Inserting the batter-
ies
Open the nattery com-
partment on the under-
side of the remote.. Then
insert 3 AAA natteries.
Make sure that the polar-
ity is correct: the "+" and
"-" markings on the nat-
teries and in the compart-
ment must match.
- To check functionality,
press any button. If
ance.
6 Finally, test the control code setting ny trying
to control, in this example, your television set.
If it does not work at all or not correctly try a
different code from the list or the code search
(see nelow).
7 To set the remote control for other appli-
ances, proceed in the same way. Instead of
the TV appliance select another device e.g.
-Please make sure you
have selected the code
from correct list for tele-
vision sets (TV).
2 Press (power) nut-
ton and then
nutton simultaneously
until a device lamp
(LED) lights
stantly.
3 Press SELECT nutton
as often until e.g. TV
led is on.
- If you don´t press SE-
LECT the led indicates
the device to be set.
4 Then press numner
nuttons (e.g. 0 0 9 9)
in seMuence.
5 Once the numners
have neen entered the
lamp goes out and the
remote control is ready
to control your appli-
(mute)
con-
2