Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
(GB)
Instructions
flickers when the button is pressed.
Adapting to appliances
In order to control your appliances you must ad-
apt or set the remote control to them. There are
two ways of doing so:
Direct control code entry using the enclosed
list
Example: setting to control a Panasonic televi-
sion set:
Vivanco GmbH, D-22926 Ahrensburg, E-Mail: hotline@vivanco.de, Helpline: +49 (0) 4102 231135
Inserting the
batteries
Open the battery com-
partment on the under-
side of the remote..
Then insert 2 AAA bat-
teries. Make sure that
the polarity is correct:
the "+" and "-" mark-
ings on the batteries
and in the compart-
ment must match.
- To check functional-
ity, press the
ton. If everything is
correct the red lamp
but-
5. 2nd number of code (tens): Press the
VOLUME-
6. 3rd number of code (ones): Press the
CH/SKIPΔ
7. Finally, press the
lamp (LED) goes out.
- To enter a 0, do not press any button.
- If lamp flashes twice code was not accepted
1. The
gives, for example,
the Panasonic Code
436.
- Please make sure you
have selected the cor-
rect list for television
sets (TV).
2. To
prepare
entry, keep the
button and the
button pressed simul-
taneously(!) until the
lamp
constantly.
3. Then enter the code
numbers as follows:
4. 1st number of code
(hundreds): Press the
VOLUME+
times for the 4 of 436.
Press as often as the
number
(1=once, 2 = twice,
etc.)
button 3 times for the 3 of 436.
button 6 times for the 6 of 436.
OK
button again briefly. The
enclosed
list
code
OK
TV
(LED)
lights
button- 4
indicates.
2
Publicité
Table des Matières
