Declaration Of Conformity; Changing The Tool - BTI UNIMASTER UM 400 SLP BB Notice Originale

OBJ_BUCH-3003-001.book Page 39 Friday, January 13, 2017 10:03 AM

Declaration of Conformity

We declare under our sole responsibility that the
product described under "Technical Data" is in
conformity with all relevant provisions of the direc-
tives 2011/65/EU, 2014/30/EU, 2006/42/EC in-
cluding their amendments and complies with the
following standards: EN 60745-1, EN 60745-2-4.
Technical file (2006/42/EC) at:
BTI Befestigungstechnik GmbH & Co. KG,
Salzstraße 51
74653 Ingelfingen
GERMANY
ppa. Stephan Uder ppa. Christian Hasenest
Head of Procurement Head of Business Unit
Department Construction
BTI Befestigungstechnik GmbH & Co. KG,
Salzstraße 51, 74653 Ingelfingen, GERMANY
Ingelfingen, 01.11.2016
Selecting the Application Tool/Accessory
Accessory
BIM segment
saw blade
Base plate
for sanding,
series Delta
93 mm
Profile sander Wood,
BIM plunge
cut saw blade,
wood and
metal
1 609 92A 3E6 • 13.1.17
Assembly

Changing the Tool

 Before any work on the machine itself, pull the
mains plug.
 Wear protective gloves when changing appli-
cation tools/accessories. Contact with the ap-
plication tool/accessory can lead to injuries.
Selecting the Application Tool/Accessory
Accessory
Material Application
Wooden materials, Separating and plunge cuts; also for sawing
Plastic, close to edges, in corners and hard to reach
Non-ferrous metals areas;
example: shortening already installed bottom
rails or door hinges, plunge cuts for adjusting
floor panels
Depends on sanding Sanding surfaces close to edges, in corners or
sheet hard to reach areas;
depending on the sanding sheet for, e.g.,
sanding wood, paint, varnish, stone
Fleeces for cleaning and for texturing wood, re-
moving rust from metal and for keying varnishes,
polishing felt for pre-polishing
Convenient, efficient sanding of profiles up to a
Pipes/Profile, diameter of 55 mm;
Paint, Red sanding sheets for sanding wood,
Varnishes, pipes/profiles, varnishes, fillers and metal
Filler,
Metal
Softwood, Smaller separating and plunge cuts;
Soft plastics, example: cutting an opening for sockets, flush
Plasterboard, cutting a copper pipe, plunge cuts in plaster-
Thin-walled board
aluminium and
Filigree adjustment work in wood;
non-ferrous metal
example: sawing openings for locks and fittings
profiles,
Thin sheet metals,
Non-hardened nails
and screws
UM 400 UM 550
English | 39