Getting Started - Hkoenig STM10 Manuel D'utilisation

HOW TO USE
This product is for household use only.

GETTING STARTED

▪ Remove all labels , tags and stickers attached to the body , or cord of the steamer and the plastic band
around the power plug.
▪ Remove and save literature .
▪ Read all the instructions before using your steamer .
IMPORTANT NOTES
▪ Using distilled , purified or filtered water is highly recommended to maintain optimal performance . Tap
water contains minerals that build up over time.
▪ Any water droplets visible inside the tank are from individual quality control tests done to ensure every
steamer meets our high standards for product performance.
▪ Do not use perfume , oils , or other additives.
▪ Always review the garment manufacturers care label instructions before steaming , and always test
fabrics forcolorfastness in inconspicuous areas (such as an inseam) . Steamers are not recommended for
use on leather, suede, vinyl, plastic, or other steam sensitive fabrics.
▪ During use the steamer and accessories will become hot . Avoid attaching or removing frames while still
hot.
▪ After preheating , prime water pump by holding the steam trigger until steam forms.
▪ It is normal to feel or hear the water pump in the handle .
▪ The water pump may become louder when the water level in the tank is low . Check and refill tank , as
needed .
BRUSH FRAMES
1. While the frame and steamer are cool, gently attach the top of the frame over the top the steamer head
and then click the bottom of the frame into place. (A)
Note: Picture①side up,Frame tab points down when in correct position.
2. Allow steamer to cool prior to removing frame. Gently pull on the tab. (B)
Note: Be careful when removing frames as condensation may build up during use.
①
A B