Enable/Disable The Remote Control; Customise The User Code - LEGRAND 674 56 Notice D'emploi

4 - Customisations

Enable/disable the remote control

✔
This setting lets you enable/disable your system's remote control. In
particular you can use the remote control to find out the state of each
zone and perform the main commands and changes of mode. For more
information consult your installer.
In the Setup menu select Remote
control with the keys
Press the key to confirm
T h e d i s p l a y s h o w s t h e w i n -
dow indicating the current state
(State: enabled)
To change the state press
To end the programming and return
to the first window keep the
pressed
The remote control base setting is enabled.
Temperature
Summer/winter
Date/time
Remote control
State:
enabled
Disable
State:
disabled
key
Enable

Customise the User code

✔
The Control unit is protected by a user code which prevents unautho-
rised people from accessing the Main menu.
The base code is 00000, but you can replace it with any 5-figure
number.
In the Setup menu select User code
with the keys
Press the key to confirm
T h e d i s p l a y s h o w s t h e w i n -
dow indicating the current state
(State: disabled)
To change the state press
The display shows the window indica-
ting the current code (00000)
You can confirm the current code by
pressing or
60
Summer/winter
Date/time
Remote control
User code
State:
disabled
Enable
Current:
00000
New:
00000
NEXT