Technical Specifications - Bosch CTL636E.6 Mode D'emploi

en

Technical specifications

Problem
Display shows
"Refill with still water
or remove filter"
Display shows
"Empty drip trays"
despite them being empty
Display shows
"Insert drip trays" even
though drip tray in use
Water dripped onto the
inner floor of the appli-
ance when the drip tray
was removed
Display shows
"Switch off with power
switch, then back on after
30 sec!"
If you are unable to solve the problem, always call the hotline!
You will find the telephone numbers at the back of these instructions.
Technical specifications
Power connection (voltage – frequency)
Heater wattage
Maximum static pump pressure
Maximum water tank capacity (without filter)
Maximum capacity of the coffee bean container
Length of power cable
Dimensions (H x B x D)
Weight, empty
Type of grinding unit
54
Cause
Water tank wrongly inserted
Carbonated water in the water
tank
Float is stuck in the water
tank
New water filter not rinsed
according to instructions, or
water filter used or defective.
Air in the water filter.
Drip tray is soiled and wet
Emptying is not detected
when the appliance is
switched off
Inside of appliance
(tray holder) dirty
The coffee grounds container
is not fully inserted
Drip tray was removed too
soon
Appliance is too warm
Dirty brewing unit
Solution
Insert water tank correctly
Fill the water tank with fresh tap
water
Remove the tank and clean
thoroughly
Rinse the water filter according to
the instructions and then switch
on, or use a new water filter.
Dip the water filter into water
until no more air bubbles
escape, replace the filter.
Clean and dry the drip tray
thoroughly
When the appliance is switched
on, remove and re-insert the
drip tray
Clean the inside
Push the coffee grounds
container all the way in
Wait a few seconds after the
last drink was dispensed before
removing the drip tray
Leave the appliance to
cool down
Clean the brewing unit
220-240 V – 50/60 Hz
1600 W
19 bar
24 l
500 g
17 m
455 x 495 x 375 mm
19-20 kg
Ceramic