Trebs 99515 Mode D'emploi page 23

2.2 Installation instructions for the camera
Remove the license plate and the current
license plate holder.
Route the cable through the hole in the car
and attach the grommet.
2.3 Operations for Android-app
Installation APP software:
1. Go to play store;
2. .Search "Sight WIFI" software, and download. The icon looks as following:
Connection WiFi:
The steps below only need to be followed on initial use. After this, the wifi car back camera is already
stored in the default settings of your mobile device.
1. Put your car in reverse after you mounted the camera. This will activate the camera. Now
you can connect to you mobile device.
2. Go to settings in the main interface of your mobile device.
3. Click "Wi-Fi ", select your camera, and connect the wifi of the mobile device terminal to the
wifi of the tool. The initial SSID of the device is "WIFICAMERA". Then type in the password of
the device (Default password: 88888888). As shown below:
Drill a hole for the wiring of the camera on
the right spot behind the license plate.
Make sure the camera has a central
position.
Tighten all screws and put the plate back on
the car. The installation of the camera is
now ready.
23