Trebs 99515 Mode D'emploi page 22

2 Installation
2.1 Installation of the emitter
Mount the transmitter using cable ties in the trunk so that it
cannot come loose. Make sure the transmitter is placed
close to the reversing lights.
PLEASE NOTE: For optimum operation, the transmitter
should be placed as far away as possible from iron / metal
parts
Test the system before the installation! Connect the camera to the wire. Install the app (see
chapter 2.3 or 2.4 below) and test whether the device is working properly by putting the car in
revise. If you receive images from the camera on you mobile device, you can clear away the
cables neatly behind interior panels or carpet using cable ties
PLEASE NOTE

The positive and negative pole of the power cable of the emitter box are connected to the
positive and negative pole of the rear lamp of the car;

Never reverse the positive and negative pole. Otherwise the emitter box and the camera can
be damaged and cannot be used;

The antenna of the emitter box shall not be near any metal part of the car. Otherwise the
emitting distance and the image transmission effect can be influenced
Connect the red cable using
the red In-Line wire
connector to the '+' of the
reverse light and the black
cable using the black in-line
wire connector to the '-'of
the reverse light.
.
22