Disposal Of Packaging; Set-Up Location Requirements - SilverCrest SUP 128 A1 Mode D'emploi

Disposal of packaging

The packaging protects the device from transport damage. The packaging
materials have been selected for their environmental friendliness and disposal
attributes, and are therefore recyclable.
Returning the packaging to the material cycle conserves raw materials and
reduces the amount of waste that is generated. Dispose of packaging material
which is no longer needed in accordance with applicable local regulations.
NOTE
► If possible, keep the original packaging of the device during the warranty
period, so that the device can be packed properly for returning in the event
of a warranty claim.

Set-up location requirements

For safe and trouble-free operation of the device, the set-up location must fulfi l
the following requirements:
■ The device must be placed on a fi rm, fl at and level surface.
■ Do not place the device in a hot, wet or extremely moist environment or in
the vicinity of fl ammable materials.
■ Do not remove the feet of the device. Otherwise there may be insuffi cient
air circulation.
■ The mains power socket must always be easily accessible so that the mains
plug can be quickly removed from the mains power socket in the case of an
emergency.
■ The surfaces of furniture and also furniture care products/polishes may possibly
contain substances that could attack the rubber feet of the device and soften
them. Put something beneath the feet of the device if necessary.
■ This device is not intended for use in areas where special conditions may exist,
such as a corrosive or potentially explosive atmosphere (dust, vapour or gas).
■ Operating temperature range: +5 to +35 °C
■ Humidity (no condensation): ≤ 75 %
SUP 128 A1
GB
IE
9